Download RobovieMaker2 User Guide
Transcript
4-3-3-1. Idling motion preference In Control map V2, you have to define an idling motion on each map as well as Control map V1, because the idling motion is needed for the controller operation to be started. To set an idling motion, click “Choose” button of “Idling motion” in “Registered motion”. After clicking, opening dialog ask you to select a motion file. Select an appropriate motion, such as a standing up motion consisting of one pose, and click “Open”. 4-3-3-2. Cancellation In Control map V2, the cancellation of the motion is supported as well as Control map V1. Using cancellation, the next motion can interrupt the performing motion instead of waiting the end of it. Using the cancellation, the operation responses of control are improved. Cancellations can be set as “Enable”/”Disable” on each motion registered in Control map V2. The cancellation of “Acceptance” and “Interrupt” are supported as well as Control map V1. In additionally, “Idling interrupt” is also supported. Thus, there are three types of cancellations. “Acceptance” – If this cancellation is enabled, the motion accepts another motions of button events regardless of cancellation setting of the next motion. “ Interrupt” – If this cancellation is enabled, the motion interrupts the another performing motion regardless of cancellation setting of the current motion. “Idling interrupt” – If this cancellation is enabled, the motion interrupts only the idling motion. This type of the cancellation is used when you want to limit the situations for the motion to be performed, such as a waking up motion started based on accelerometers. Although enabling cancellation improves response of the controller, it also causes an immediate servomotor movement as well as the start of the motion and the stop of the motion, because the cancellation of the motion causes decoupling motion. Since this immediate movement of the servomotors consumes lots of energy, voltage supplied to the CPU board sometimes drops. Be careful not to immediately move the servomotor. In a worse case, the CPU board reboots because of the low voltage. To change the setting of the cancellations, select the motion you want to change the 79