Download Hardware User Manual
Transcript
Pin No. 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 Signal Name PF13 / PPID13 / TSCLK1 / SPISEL3 / CUD PF11 / PPID11 / TFS1 / CZM PF9 / PPID9 / RSCLK1 / SPISEL6 PF7 / PPID7 / DR0SEC / ND_D7A / TACI1 PF5 / PPID5 / TSCLK0 / ND_D5A / TACLK1 PF3 / PPID3 / DT0PRI / ND_D3A PF1 / PPID1 / RFS0 / ND_D1A GND GND USB_VBUS PG10 / TMR6 / TSCLK0A / TACI6 NC2) or PH9/SPISEL5/ETxD2/HOST_D9/TACLK3 SCL PG0 / HWAIT PH14/ND_CLE/ERxDV/HOST_D14 PH12/ND_RE/ERxD3/HOST_D12 PH10/ND_CE/ERxD2/HOST_D10 Type IO IO IO IO IO IO IO Power Power I/O IO IO – 10k pull down O IO IO IO IO Function PPI data, SPORT PPI data, SPORT PPI data, SPORT PPI data, SPORT, NAND interface PPI data, SPORT, NAND interface PPI data, SPORT, NAND interface PPI data, SPORT, NAND interface USB Timer, SPORT I2C Boot host wait NAND interface NAND interface NAND interface Table 4-1: Connector description X1 1) Internally connected to 2.5V. If you want to program the OTP memory, just power this pin with 7.0V. These IO pins are normally used to access more flash memory. They should not be used as general purpose IO pins. 2) For more information please see chapter 2.3. 4.2 Connector X2 Pin No. 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 Signal Name A1 A3 A5 A7 A9 A11 A13 A15 A17 A19 ABE1 LED_ACT GND RX+ RXARDY USBD+ SCLK GND AMS3 AWE NMI CM-BF527_HUM_V2.2.docx Type O O O O O O O O O O O IO Power IO – 49R9 pull up to 2V5 IO – 49R9 pull up to 2V5 I I/O O Power O O I -10k pull up Function Address bus Address bus Address bus Address bus Address bus Address bus Address bus Address bus Address bus Address bus Byte Enable Ethernet Ethernet Ethernet Hardware ready control USB SPI Memory select Write Enable Non makeable interrupt 16