Download 5300-5600_BASIC_Reference_en-US_RevA

Transcript
STALL.JUMP
parameter
(integer)
Purpose
STALL.JUMP moves program execution to a specified line in the
program when a stall occurs.
Note: Refer to Section 2.6, “Stall Detection Function” for additional
information.
Syntax
STALL.JUMP = x
x = the desired line number
x = 0 for no jump
Range
Related
instructions
x=0
STALL.DEADBAND — sets the maximum allowed difference in motor
steps (microsteps) between encoder and pulse counts that can occur
before a stall is triggered.
STALL.ERROR — indicates that a stall has occurred.
STALL.STOP — stops the motor when stall occurs.
Programming
guidelines
•
•
Rev F
Install an encoder and verify that it is set to the correct
ENCODER line count.
Make sure STEPSIZE is correct. (Both hardware and software)
StepperBASIC Reference Manual
3 - 157