Download PTQ-PDPMV1 - Schneider Electric

Configuring the Processor with Concept
6
PTQ-PDPMV1 ♦ Quantum/Unity Platform
PROFIBUS DP V1 Master
After the import procedure is concluded the following window is displayed.
Click OK:
The following warning is displayed (this is expected).
7
4.6
At Concept Converter click File-Exit.
Step 3 - Setup the Concept Project
1
2
3
4
Start Concept Version 2.6.
Open the File menu, and then choose New Project.
Open the File menu again, and then click Save Project As…
Navigate to C:\project, and enter PTQPROJ as the file name. Click OK to
save the file.
Configure the general settings for your application. Select the correct
Quantum processor type (PLC Selection) and other modules that will be
located at the Quantum rack.
6 In PLC Configuration double-click PLC Memory Partition. Verify that the
number of input registers and output registers are sufficient for your
application.
5
Note: You can view the number of input and output words required for your
PTQ-PDPMV1 application in the Diagnostics window in ProSoft Configuration
ProSoft Technology, Inc.
May 30, 2007
Page 81 of 238