Download Carlson Explorer User Guide

Your Carlson Explorer
This is a technical reference for the Carlson Explorer, Carlson Explorer II and the Carlson Explorere 600+ data
collector.
Attention: Read This First!
PLEASE READ THE INSTRUCTIONS BELOW BEFORE OPERATING YOUR UNIT
Are You Registered? Be sure you product is properly registered. It is possible that your dealer did not
transfer the registration from his company to yours. To register, visit our web site at www.carlsonsw.com, select the
Support tab, select Product Registration and then Carlson SurvCE registration.
If you encounter problems there are instructions in our website Knowledge Base, under Support, or you
may fill out the information on the back of this form and fax to Carlson Software. Our fax number is 606-564-6422.
As you get started, make special note of these three key items:
1. CAUTION! Do Not Remove the Battery to Reboot
To reboot, hold the On/Off key down for 10 seconds.
2. IMPORTANT! Regarding Job Storage on the Carlson Explorer
All job files must be stored to the internal CF card (''hard drive'') named system CF. In the event of a power
loss or necessary hard reboot, this card will preserve these files. Job files stored in all other on-board locations,
including the desktop, are vulnerable to deletion in the event of a power loss. The external CF card is not affected
Chapter 1. Basic Information
2