Download USER`S AND PROGRAMMING MANUAL

5.8. OPERATION AND PARAMETERS OF CURRENT OUTPUTS
First of all a device should be assigned to the current output, (Main menu / Current outputs / Program / Source).
The result of the transmitters marked with
are added.
The result of the transmitters marked with
is deducted from the sum of the result of the transmitters marked with
. (difference measurement)
Computes the average of the results of the transmitters marked with
Secondly the relevant function should be selected and configured in Main menu/ Current outputs /Program/Function. Finally the parameters have to be
programmed such that the values of the dimensions of CP1 and CP2 be determined by the transmitter(s). Thus if the measurement mode is LEVEL [m]
(e.g. for SE-300 P01=x1 P00=00x), then the programming has to be in LEVEL [m] too (Main menu/ Current outputs /Program/Parameter).
For a detailed overview of the programming steps see Appendix 4.
5.8.1. Selection of Current outputs
It is impossible to enter the current output menu if the system does not contain a single current output. The number of relays in the system can be viewed
under Main menu/MultiCONT config/ Report. (See chapter 5.4.9)
Main menu
05
Devices
Relays
Current outs.
Inputs
UIM-s
MultiCONT config.
Default config
Select using
&
Current outs.
01: C1_IN
02: C12MB
:
12: C12n
List number
of curr. out
18
01: C1_IN
Programming
Short TAG
Info
19
Curr. output ID
Short TAG
Active
Not active (de-energised relay)
prw1101a0600p_05.doc ♦ 69 / 89