Download Acquisition Manual

Transcript
The Acquire Menu
A-48
DR (digitizer resolution)
Acquisition commands will normally set the digitzer to its maximum resolution
(the default of DR). If you set DR to a smaller value,
acquisition will start with the
INDEX
modified setting.
DONE
INDEX
DDR (digital digitizer resolution)
For spectrometers equipped with digital filters (Avance) only. For details see: DIGMOD parameter.
DE (pre-scan delay in microseconds)
A waiting period between the last pulse and the begin of data acquisition (digitizer
start) to avoid pulse feed through. You may change DE by entering a new value.
DE includes the sections, DE1 and DE2 (Figure 1.6). After DE1 the receiver gate
is opened.
For AMX/ARX type spectrometers, the program calculates DE according to
DE=1.4288*DW (or half this value if AQ_mod=qf). DE1 and DE2 are constants.
For Avance type spectrometers, you may change DE1 and DE2 using the command edscon. See edscon for details.
PHP (preamplifier module selection)
AMX/ARX type instruments only. 0=X-BB(HR), 2=X-QNP(HR), 8=X-BB(HP),
10=X-QNP(HP).
QNP (QNP selection)
An integer number (1-4) is required.
HL1-HL4, (ecoupler high power levels in db)
FL1-FL4 (F19 decoupler high power levels in db)
XL, YL (BSV!0-X, BSV!0-X power level)
ZL1-ZL4 (4th channel low power levels in db)
AMX/ARX type instruments only. The pulse program commands hl1-hl4 and fl1fl4 may be used to enable the respective high power level of the ecoupler or 19F
decoupler. The default power (which is set if power is not explicitely switched with
hl1-hl4) is HL1 (and FL1 for F19).
If the spectrometer is equipped with a 4th channel, the pulse program commands
zl1-zl4 may be used to set the low power according to the parameters ZL1-ZL4.
The command zlo switches the 4th channel decoupler to low power mode, zhi to
high power mode. There is no possibility of controlling the high power.