Download CM1000 - Belver Brasil
Transcript
Chapter 5 Options 5.6.5 Frequency Selection The user may select the frequency from the frequencies entered in the setup screen by using the F1 NEXT FIELD/F2 PREV FIELD keys to highlight the Frequency and using the arrow keys to sequence through the setup frequencies stored in memory. If the generator is on and the user makes any frequency change, the generator is toggled to the off condition and must be turned back on. All settings are remembered between uses. The frequency range is 5 to 45 MHz (less ½ of the bandwidth for the QAM modulation). 5.6.6 Output Amplitude Setting The user may set the amplitude for the upstream signal by using F1 NEXT FIELD/F2 PREV FIELD keys to select the LEVEL entry box and using the arrow keys to increment or decrement the level in 1.0 dB steps. The generator is on during level adjustment. The range of level is from +8 to +60 dBmV. 5.6.7 Symbol Rate Setting The user may also select the symbol rate by using the F1 NEXT FIELD /F2 PREV FIELD keys to highlight the symbol rate and then use the arrow keys to select the desired symbol rate. The supported rates are 5.12, 2.56 and 1.28 M Symbols/S. The bandwidth for each symbol rate is displayed, but not selectable. 5.6.8 Start & Stop The START/STOP (F3) key controls the generator output. The output toggles between on and off by pressing the START/STOP (F3) key. When the generator is on the F3 key is labeled STOP. When the generator is OFF, F3 is labeled START. After pressing the F3 START key, there is a slight delay in turning on the generator. When the generator output is on, “Generator ON” is displayed in the top right area of the screen. The output will automatically switch to the off condition if the user selects the Frequency setting and presses any ARROW key to change the frequency. The initial default settings for CM-USG are a frequency of 5 MHz for all channels and +8 dBmV with a 2.56 MB/S symbol rate. 139