Download Multiprotocol Rail Reader User Guide

Chapter 11
AT5720 Check Tag-to-MPRR Assembly
This document describes the procedures to assemble and connect a
check tag assembly to a Multiprotocol Rail Reader (MPRR).
Required Supplies
Before assembling the check tag antenna kit, make sure you have the necessary supplies and tools for this task. Check Tag Kit (TransCore P/N 19114-00). Table 11-1 lists
the kit parts.
Table 11-1 Check Tag Kit Parts List
Quantity Description
1
Terminal connector strip (9 position)
2
Self-tapping screw
1
Plastic connector housing sleeve
2
Plastic nut cap with rubber insert
1
Nylon closing cap
1
Check Tag Assembly Instructions
You need the following additional materials and/or tools to complete the installation.
•
AT5720 Check Tag(s)
•
Jeweler flat-blade screwdriver
•
Standard tools (Phillips screwdriver, wire stripper, crescent wrench)
•
Multiprotocol Rail Reader
Procedures
To assemble the kit for two check tags
1. Strip the cable insulation to expose the three check tag wires. Strip wire
insulation approximately 1/4 inches to expose bare wire. Slide the plastic nut and
rubber grommet over the wires (Figure 11-1).
11-3