Download DVC6000f Digital Valve Controllers
Transcript
PID Function Block where BKCAL IN CAS IN FF TRK IN TRK BKCAL_IN GAIN: proportional gain value BKCAL OUT τr: integral action time constant (RESET parameter) in seconds IN s: laplace operator D τd: derivative action time constant (RATE parameter) α: fixed smoothing factor of 0.1 applied to RATE F: feedforward control contribution from the feedforward input (FF_VAL) E: error between setpoint and process variable VAL OUT PID VAL = THE ANALOG INPUT VALUE AND STATUS FROM ANOTHER BLOCK’S BKCAL _OUT OUTPUT THAT IS USED FOR BACKWARD OUTPUT TRACKING FOR BUMPLESS TRANSFER AND TO PASS LIMIT STATUS. CAS_IN = THE REMOTE SETPOINT VALUE FROM ANOTHER FUNCTION FF_VAL = THE FEEDFORWARD CONTROL INPUT VALUE AND STATUS. IN = THE CONNECTION FOR THE PROCESS VARIABLEFROM BLOCK. ANOTHER FUNCTION BLOCK. TRK_IN_D = INITIATES THE EXTERNAL TRACKING FUNCTION. TRK_VAL = THE VALUE AFTER SCALING APPLIED TO OUT IN LOCAL OVERRIDE MODE. BKCAL_OUT = THE VALUE AND STATUS REQUIRED BY THE BKCAL_IN INPUT OF ANOTHER FUNCTION BLOCK TO PREVENT RESET WINDUP AND TO PROVIDE BUMPLESS TRANSFER TO CLOSED LOOP CONTROL. OUT = THE BLOCK OUTPUT AND STATUS. To further customize the block for use in your application, you can configure filtering, feedforward inputs, tracking inputs, setpoint and output limiting, PID equation structures, and block output action. Table 4-31 lists the PID block parameters and their descriptions, units of measure, and index numbers, and figure 4-12 illustrates the internal components of the PID function block. B2720 / IL Figure 4-11. Proportional+Integral+Derivative (PID) Function Block Modes The PID function block supports the following modes: Manual (Man)—The block output (OUT [9]) may be set manually. Automatic (Auto)—The SP [8] may be set manually and the block algorithm calculates OUT [9]. PID Function Block Overview The PID function block combines all of the necessary logic to perform proportional/integral/derivative (PID) control. The block supports mode control, signal scaling and limiting, feedforward control, override tracking, alarm limit detection, and signal status propagation. The block supports two forms of the PID equation: Standard and Series. You can choose the appropriate equation using the MATHFORM [70] parameter. The Standard ISA PID equation is the default selection. Standard Out + GAIN Series Out + GAIN ex ǒ1 ) t s 1) 1 ) T r ex Ǔ t ds )F t ds ) 1 ǒ1 ) t1sǓ ) ǒT t st)s 1) 1Ǔ )F d r d Cascade (Cas)—The SP [8] is calculated in another block and is provided to the PID block through the CAS_IN [18] connection. RemoteCascade (RCas)—The SP [8] is provided by a host computer that writes to the RCAS_IN [32] parameter. RemoteOutput (ROut)—The OUT [9] is provided by a host computer that writes to the ROUT_IN [33] parameter. Local Override (LO)—The track function is active. OUT [9] is set by TRK_VAL [39]. The BLOCK_ERR [6] parameter shows Local override. Initialization Manual (IMan)—The output path is not complete (for example, the cascade−to−slave path might not be open). In IMan mode, OUT [9] tracks BKCAL_IN [27]. Out of Service (OOS)—The block is not processed. The OUT [9] status is set to Bad: Out of December 2009 4-83 4