Download 2. the dspec 50
Transcript
932502E / 0914 5. SPECIFICATIONS HIGH VOLTAGE (one HV module per chassis) ! Positive 0–5 kV Rear-panel SHV connector, 500 V–5 kV. Computer controlled. Only active when the unit is set for positive bias. ! Negative 0–5 kV Rear-panel SHV connector, 500 V–5 kV. Computer controlled. Only active when the unit is set for negative bias. SHUTDOWN IN Rear-panel BNC turns off the bias supply voltage when the detector is warm. Software-selectable ORTEC or TTL mode (SMART-1 detectors auto-select the SMART shutdown mode). In ORTEC mode, the detector Bias Shutdown must be connected to this input or the high voltage will not turn on. CHANGE SAMPLE OUT Rear-panel BNC connector, TTL compatible. SAMPLE READY IN Rear-panel BNC connector accepts TTL level signal from sample changer. ETHERNET Standard 10/100 Mbit Ethernet connection. Link and Activity LEDs are integrated into the connector. Use dynamic or static IP addressing. USB Emulates a USB connection. ORTEC CONNECTIONS software supports up to 255 USBconnected devices per computer. SD SecureDigital™ (SD) memory card slot for uploading a maximum of 9 optional .JPGformat image files. RESET For system maintenance performed in conjunction with the ORTEC Global Service Center. 5.1.2. Electrical and Mechanical Dimensions 42.6 cm W × 35.6 cm D × 15.3 cm H (16.8 in. W × 14.0 in. D × 6.0 in. H). Weight 11 kg (24.3 lbs). Operating Temperature Range 0EC to +50EC, including touchscreen. Power 100–240 V ac, 47–63 Hz, 110 watts. For 100 or 120 V ac line voltage, one fuse, 2 A (SB) size 3AG required. For 230 or 240 V ac line voltage, two fuses, 1 A(T) size 5×20 mm required. 63