Download Programming Software Version 4.0 User Manual

Programming Software User Manual
BACK PANEL SWITCH SETTINGS
Set CTS Switch to always ON
(the 0, or down position).
Set Switches SW1 through SW4 in the OFF
position as shown in the figure below. This
is the Single-Link setting.
↓
↓
ON
1 2 3
Switch No.
Function
1
Not used
ON
OFF
2
3
Operation
1:N
1:1
4
5V Power Supply
Present
Absent
4
Appendix C
PLC Setup
OpenPowerPanel
Programming Software and
configure
Project
Information as shown in the
figure to the right.
After selecting the PLC
Type and Protocol, click on
View/Edit PLC Com
Setup. The PLC Attributes
dialog box will appear.
Enter the parameters
shown. Click on the OK
button to save your
selections. You will return to
the Project Information
screen. Click on the OK
button to begin creatingyour
PowerPanel
Project.
NOTE on TAGs for this type PLC:
If communicating to other than
the default Host Link Unit, the
address string must be preceded
by the Host Link Number of the
unit you want to communicate
with. For example, 2-HR05 is
Host Link Unit 2.
C-20