Download "user manual"

Transcript
Chapter 4: User Peripherals
4.13.5.1.8 Device Configuration
When a device is first connected to the PC, its signalling speed is discovered and it will have Endpoint 0
configured to accept a control pipe. In addition, every new device that is plugged onto the network will be
assigned address zero. This way the PC knows what bit rate to use and will have one control channel available at
address zero endpoint zero. This control pipe is then used by the PC to discover the capabilities of the new
device and to add it to the network. The process the PC uses to gather this information is called “Enumeration”.
So in addition to configuring the USB peripheral on the STR9 you need to provide some firmware that responds to
the PC enumeration requests.
The data that the PC requests is held in a hierarchy of descriptors. The descriptors are simply arrays of data that
must be transferred to the PC in response to enumeration requests. As you can see from the picture below it is
possible to build complex device configurations because the USB network has been designed to be as flexible
and as future proof as possible. However the minimum number of descriptors required is a device descriptor,
configuration descriptor, interface descriptor and three endpoint descriptors (one control, one IN and one OUT
pipe).
The configuration information for
every USB node is described as a
hierarchy of descriptors which are
transferred to the PC during the
device enumeration procedure.
4.13.5.1.9 Device Descriptor
At the top of the descriptor tree is the device descriptor. This descriptor contains the basic information about the
device. Included in this descriptor is a vendor ID and product ID field. These are two unique numbers that identify
what device has been connected. The windows operating system will use these numbers to determine what
device driver to load. The vendor ID number is the number assigned to each company producing USB-based
devices. The USB implementers’ forum is in charge of administering the assignment of vendor IDs. You can
purchase a vendor ID from their website (www.usb.org) for $1500 administration charge (they must be very
heavy) or $2500 if you want to use the USB logo on your product. Either way you must have a vendor ID if you
want to sell a USB product on the open market. The product ID is a second 16-bit field which contains a number
assigned by the manufacturer to identify a specific product. The device descriptor also contains a maximum
packet size field.
© Hitex (UK) Ltd.
Page 149