Download Report 2 - CSA Group

S ECTION 2
SETUP AND INSTALLATION
Assembling the
Tripod
An optional tripod is available for installation on the roof of a sampling
building.
To assemble the tripod:
1. Locate a tripod foot and remove the rubber leg holder, if one is
attached.
2. Place one leg of the tripod onto the tripod foot.
3. Place a metal bracket over the rubber base of the tripod leg and into
the two slots on the tripod foot (Figure 2-8). Ensure that the bracket is
placed over the rubber base on the end of the tripod leg.
Figure 2-8.
Placing the metal bracket on the
tripod foot.
4. Insert a plain washer then a lock washer onto each threaded end of the
bracket, then install the nuts on the threaded ends of the bracket and
tighten them with a 3/8" (or adjustable) wrench.
Note. Hand-tighten both nuts on the bracket before tightening
them with the wrench to ensure that the bracket is positioned
properly on the tripod leg and tripod foot. ▲
5. Repeat steps 1 through 4 for each leg of the tripod.
2-8 OPERATING GUIDE, TEOM 1405-DF
THERMO FISHER SCIENTIFIC