Download M & J
Transcript
DZB Series Function Code DZB Series Chapter 5 Function Parameters L ist De fault Value Settin g Ran ge Name Modifi Serial cation No Function Code Chapter 5 Function Parameters List 8:AI input value 7:DC bus voltage 128 9~10 :Reserved 8:PID set point 256 9:PID feedbac k 512 F2.23 AO L ower limit 0. 0%~100.0% 0.0% ※ 74. F2.24 Lo wer limit corresponding AO o utpu t 0. 0V~10.0V 0.0V ※ 75. F2.25 AO Upper limit 0. 0%~100.0% 100.0% ※ 76. F2.26 Upper limit corresponding AO o utpu t 0. 0V~10.0V 10.0V ※ 77. User password F3.01 Reserved F3.02 11:Reserved 12: VI value 0~9999 0 ※ F3.06 Reserved 80. STOP fun ction option 1:Keypad an d termi nal control vali d 2:Keypad an d commu nication control val id 0 ※ Stop status display par ameter option 0:external keyboard preferential ENB 1:Local a nd exter nal keyboard sim ultaneous display, only external key-pr ess is valid. Keypad d isplay option 2:Local p anel an d external keyboard sim ultaneous disp lay, only Local key-press is valid. 0 ※ 82. 3:Local and external keyboard simultaneous display, and all key-presses are valid (both are OR logical relation) Displayed M essage F3.05 operat ion status display parameter option 8192 14: Current segment of multi-speed control 16384 Setting frequency 1 DC bus volt age 2 Input terminal status 4 Output terminal status 8 PI D setpoint 16 PI D feedback 32 Co de VI value 64 AI value 128 C urrent segment of multi-speed control 256 Act ual delay time 512 Sett ing delay t ime 1024 0- 14 (0: in vali d) F3.08 IGBT mo dule temperatur e 0~100.0℃ F3.09 Software version F3.10 Accumulative op erating time F3.11 The fault before pr evious fault type 1:IGBT U p hase protecti on(E009) F3.12 Previous faul t type 2:IGBT V pha se pro tection (E019) ** 90. F3.13 Current fault type 3:IGBT W ph ase protection(E0 29) ** 91. 0~9999h 2:O utput current 4 3:O utput voltage 8 4:Running speed 16 5:Actual delay t ime 32 5:Deceleration o ve r-curre nt(E005) 6:Set ting delay time 64 6:Constan t speed o ver-current (E0 06) 83. 0 0 ※ 85 . ** 86. ** 87. ** 88. ** 89. 0:No fault 1 2 - 27- 84. operation st atus display p r eferential option 1:Running f requency ※ ※ F3.07 0:Set ting frequency 255 255 81. 3:Al l co ntrol m odes valid F3.04 4096 13: AI value 78. 79. 0:Keypad control valid F3.03 Modifi Serial ca tio n No 10:Reserved F3 Human Machine Interface Parameter s F3.00 Default Value Setting Range Name 4:Acce leration over -current(E004) -2 8 -