Download EnGenius L2 Switch CLI Manual
Transcript
Clock Source Syntax clock source (local|sntp) Parameter local Sntp Specify to use static time Specify to use sntp time Default Default is using local time. Mode Global Configuration Usage Use the clock source command to set the source of time. “local” means that you use the static setting by the user manual set. The “sntp” means that you use the remote SNTP server. Use the no form of this command to reset to default settings. Example The example shows how to set clock source of switch. You can verify settings by the following show show clock command. switch(config)# clock source sntp 712
Related documents
Command Line Interface User Guide
EnGenius EGS7228P network switch
Edge-Core ES3528M-SFP
GS1900 Series User's Guide - Server 2
EOS User Manual
XS3900-48F User's Guide
GS2200-24(P) User's Guide (January 2010) - Server 2
Stratix 8000 and Stratix 8300 Ethernet Managed Switches Release
TigerSwitch 10/100 Management Guide
Layer 2 Managed Stackable Switches
EOS System Message Guide
RMX-111 User Manual