Download EnGenius L2 Switch CLI Manual

Transcript
Clock Source
Syntax
clock source (local|sntp)
Parameter
local
Sntp
Specify to use static time
Specify to use sntp time
Default
Default is using local time.
Mode
Global Configuration
Usage
Use the clock source command to set the source of time. “local” means that you use the static setting by the user manual
set. The “sntp” means that you use the remote SNTP server. Use the no form of this command to reset to default settings.
Example
The example shows how to set clock source of switch. You can verify settings by the following show show clock command.
switch(config)#
clock source sntp
712