Download JetNet 4706_series_User Manual v1.02

The following figure is the popup alert window when the incorrect username is entered.
4.2.3
IP Configuration
This function allows users to configure the switch’s IP address settings.
DHCP Client: Enable or Disable DHCP Client function. When DHCP Client function is
enabled, an IP address will be assigned to the switch from the network’s DHCP server. In
this mode, the default IP address will be replaced by the one assigned by the DHCP server.
If DHCP Client is disabled, then the IP address that you specified will be used instead.
IP Address: You can assign the IP address reserved by your network for your JetNet. If
DHCP Client function is enabled, you don’t need to assign an IP address, as it will be
overwritten by the DHCP server. The default IP address is 192.168.10.1.
Subnet Mask: Assign the subnet mask for the IP address. If DHCP Client function is
enabled, you don’t need to assign the subnet mask. The default Subnet Mask is
255.255.255.0. Note: In the CLI, we use the enabled subnet mask to represent the
number displayed in the web UI. For example, 8 stands for 255.0.0.0; 16 stands for
255.255.0.0; 24 stands for 255.255.255.0.
Gateway: Assign the gateway for the switch. The default gateway is 192.168.10.254.
Note: In the CLI, we use 0.0.0.0/0 to represent the default gateway.
Once you finish configuring the settings, click Apply to apply your configuration.
JetNet 4706/4706f Industrial Managed PoE Switch
24