Download MV100 Series

Transcript
Operation Instruction of MV100 Series Inverter
inverter’s input or output terminals to the inverter's shell, otherwise
you may get an electric shock.
• Please make sure that the voltage of the power supply and the
voltage of the inverter are same, otherwise it may cause the
inverter fault or personnel injury.
• The power supply cables must be connected to R,S,T. Never
connect the power cable to the U,V,W of the inverter.Doing so will
damage the inverter.
• Please do not conduct pressure resistance test to the inverter,
otherwise it may cause the inverter’s internal fault.
• Please install accessories such as brake units, brake resistors
in accordance with the regulations of the instruction manual,
otherwise it may cause the inverter fault or fire.
• Please ensure that the screws of the terminals are firmly locked,
otherwise it may cause the inverter fault.
1-4 Power-on, Test operation
Warning
• While power is on or when the inverter is running, do not open the
front cover. Otherwise you may get an electric shock.
• Do not run the inverter with the front cover or wiring cover
removed. Otherwise, you may access the exposed high-voltage
terminals or the charging part of the circuitry and get an electric
shock.
• Before starting operation , confirm and adjust the parameters. A
failure to do so may cause some machines to make unexpected
motions.
• It is recommended to undertake test runs with no load.
• Please provide an emergency stop switch when the “stop” function
setting is unavailable.
• Do not use the inverter input side magnetic contactor to start/stop
·4·