Download Technical Description - SMA Solar Technology AG
Transcript
Sunny Boy 2000 Technical Description 2.3 Technical Design of the Sunny Boy 2000 The main feature of the Sunny Boy 2000 is the simple and absolutely sturdy design with outstanding reliability and high efficiency. The PV-plant’s DC voltage is converted to a DC circuit with a high frequency step-up converter (16 kHz). From this intermediate circuit the grid feeding is done directly with an IGBT bridge. filter surge voltage protection 125 V...500 V 0...10 A filter surge voltage protection mains bridge relay mains relay RISO board supply VPV IAC sequential control system fAC L 195...253 V 50 Hz N VAC current control system modem (optional) PE MSD 1 MSD 2 Fig. 2.1: Block Circuit Diagram of Sunny Boy 2000 The string inverter’s nominal power is dimensioned for the serial connection of a maximum of 20 modules (with 36 to 40 cells each). It is possible to connect two separate strings parallel to the Sunny Boy depending on the PV-module type used. The management of feeding current with a one-chip micro-controller guarantees an absolutely sine-formed curve with extremely low harmonic distortion. The SCS provides fully automatic functioning of the system as well as the MPP-tracking (MPP = detection of the voltage point with maximum power, Maximum Power Point). Unnecessary losses resulting from stand-by operation and during operation are avoided. The heat sink of the Sunny Boy disposes of the inevitable power loss resulting from switching the power semiconductors. It is large enough to enable the Sunny Boy to SB2000-11:EE - 11 - SMA Regelsysteme GmbH