Download 6 Connecting the Camera

VNP Camera Link series
7.3
Power Input Receptacle
The power input receptacle is a Hirose 6 pin connector (part # HR10A-7R-6PB). Pin arrangement and
configuration are as follows:
1
6
3
4
2
5
Figure 7.3 Pin Arrangement of Power Input Receptacle
Pin Number
Signal
Type
Description
1, 2 , 3
+ 12 V DC
Input
DC Power Input
4,5,6
DC Ground
Input
DC Ground
Table 6.2 Pin Configuration of Power Input Receptacle
Connecting the power cable to the camera can be made by using the Hirose 6 pin plug (part # HR10A-7P-6S) or
the equivalent. The power adaptor is recommended to have at least 1A current output at 12 V DC ±10% voltage
output (Users need to purchase the power adaptor separately).
Precaution for Power Input

Make sure the power is turned off before connecting the power cord to the camera.
Otherwise, damage to the camera may result.

If the camera input voltage is greater than specified input voltage range, damage to the
camera may result.
Page 18 of 85
RA14-134-015