Download XL Remote Commands

C.5 Scanning Commands
Command:
SCANNING?
Description:
Reads the scanning flag. This value determines whether or not the XL™ is set to
scan.
Parameters:
None.
Response:
The response will be either the “ON” or “OFF”.
Examples:
-> SCANNING?5
OFFrs
Command:
SCANNING=XXX
Description:
Set the scanning flag.
Parameters:
This flag can be set to either “ON” or “OFF”.
Response:
None.
Example:
-> SCANNING=ON5
rs
Command
SCANRATE?
Description:
Read the current scan rate interval.
Parameters:
None.
Response:
An ASCII text string is returned with the time formatted as hh:mm:ss. The
response is terminated using a carriage return, line feed.
Example:
-> SCANRATE?5
00:00:30rs
Command:
SCANRATE=hh:mm:ss
Description:
Set the time interval for the scanning operation. Keep in mind that the scan rate
should be as fast as, or some multiple faster than the report intervals. See the note
at the end of this section.
XL™ SERIES
Command sent to the XL™.
Response sent to the host system.
Command sent to the XL™
Response from the XL™.
Command sent to the XL™.
Response sent to the host system.
Remote Operation (Command Mode) C-21