Download IS-IS Configuration

Chapter 20 MPLS VPN Configuration
CE2#sh ip route
Gateway of last resort is not set
100.0.0.0/24 is subnetted, 1 subnets
O
E2
100.1.1.0
[110/1]
via
10.10.10.1,
00:07:21,
FastEthernet0/0.10
C
200.1.1.0/24 is directly connected, Loopback1
10.0.0.0/24 is subnetted, 2 subnets
O
E2
10.1.1.0
[110/1]
via
10.10.10.1,
00:07:21,
directly
connected,
FastEthernet0/0.10
C
10.10.10.0
is
FastEthernet0/0.10
CE2#
MPLS VPN Maintenance and
Diagnosis
Purpose
Prerequisite
Steps
Refer to below procedure for MPLS-VPN maintenance and
diagnosis on ZTE ZXR10 GER router.
Router Command Line Interface has been accessed.
1. To check network connectivity, use ping vrf <vrf-name>
<ip-address> command in privileged mode, as shown in
Table 341.
TABLE 341 PING VRF COMM AND
Command
Format
Command
Mode
ping vrf
<vrf-name>
<ip-address>
Privileged
Command Function
This checks the VPN network
connectivity
Result: This checks the VPN network connectivity.
In the following example, to ping the address of CE1. VRF
must be designated:
PE1#ping vrf test1 10.1.1.2
sending 5,100-byte ICMP echos to 10.1.1.2,timeout is 2
seconds.
!!!!!
Success
rate
is
100
percent(5/5),round-trip
min/avg/max= 0/4/20 ms.
PE1#
2. To display some configuration information about VRF, use
show ip vrf command in privileged mode as shown in Table
342.
Confidential and Proprietary Information of ZTE CORPORATION
299