Download User Manual - Skip

3.2
DL-08/09 System Association
When used with an SM-5 system (through the RS485 connector) or an SC12 system (through the CAN connector), this step is not necessary.
For DL-08/09 data sources, the CVO-312 must be associated with the
wireless network before data will be available and viewable on the screen.
This process is described in the DL-08/09 manual. For your convenience,
this section of the manual has been copied into this manual as Appendix
A.
3.3 DL-08/09 Selection of Overlay Monitor
Items
Important
Note!
When used with an SM-5 system (through the RS485
connector) or an SC-12 system (through the CAN
connector), this step is not necessary. Follow
instructions in Section 4.2, “Main Screen Setup Menu”.
For DL-08/09 data sources, you must select monitor items to be transmitted
from the Skip-Line Data Logger laptop or tablet PC to the CVO-312. Any
item that can be monitored on the data logger PC can be transmitted to the
CVO-312. There are six video overlay item “slots” on the CVO-312 device.
These six slots may be all used or none used. When unused, the slot will
remain blank and transparent on the main screen. The process of selecting
items to display is described in the DL-08/09 manual. For your convenience,
this section of the manual has been copied into this manual as Appendix
B.
3.4
Touch Calibration and Initial Setup
This screen is typically not needed if your monitor was purchased with your
CVO-312, as your CVO-312 device was calibrated to your monitor at the
factory. If this is the case, you should skip ahead to section 4.2.
Page 15