Download User manual

The Real Time Streaming Protocol (RTSP)
ia a network protocol used to establish and
control media sessions between devices.
For example, a video Decoder sends
RTSP play command to the video Encoder.
Note! If port clash is detected while
configuring RTSP server port, device gives
an error message and disables RTSP
server. After that you have to give an
unused (valid) port and enable RTSP
server again.
Session Announcement Protocol (SAP) is a
protocol for broadcasting multicast session
information. A SAP listening application can
listen to the SAP multicast IP address and
construct a guide of all advertised multicast
sessions (RFC 2974). SAP uses Session
Description Protocol (SDP) as the format of
the session descriptions. Announcement
data is sent using IP multicast and UDP.
Services settings
Network Services
HTTP enabled:
HTTP port:
HTTPS enabled:
HTTPS port:
RTSP enabled:
RTSP port:
Enabled TLS versions
TLS 1.0:
TLS 1.1:
TLS 1.2:
HTTP Digest Authentication
Enabled:
Session Announcement Protocol (SAP)
Enabled:
Multicast TTL:
Announcement interval:
Administrative scope:
40
Click “Services” under the Administration menu. Services Settings
page appears on the screen. This page allows you to enable/disable
different network services available and configure following parameters
of services:
_________________________________________________________
HTTP is always enabled.
Port 80 is used always.
Enable/disable HTTPS.
Configure HTTPS server port.
Enable/disable RTSP (Real time streaming protocol) server.
Configure RTSP server port.
_________________________________________________________
Enable/Disable Transport Layer Security protocol 1.0 (RFC 2246).
Enable/Disable Transport Layer Security protocol 1.1 (RFC 4346).
Enable/Disable Transport Layer Security protocol 1.2 (RFC 5246).
_________________________________________________________
Enable/Disable HTTP digest access authentication (RFC 2069).
Note! When is enabled, authentication is mandatory for all profile
based JPEG snapshot download.
_________________________________________________________
Enable/Disable Session Announcement protocol (RFC 2974).
Multicast Time-To-Live for SAP packets (1...255).
SAP timing in seconds (1...999). Retransmit time of SAP-packet. This
time has to be same at both encoder and decoder pairs.
Range of multicast IP addresses advertised with SAP. When the stream
multicast address is within the SAP scope, end of the scope is used.
Otherwise default SAP-address 224.2.127.254 is used. Default SAPscope is 239.0.0.0 - 239.255.255.255.
MPH100/400 series video encoders WebUI user manual