Download User manual

Hint! You can open sdp file with the VLC player to
view the stream, but notice the following requirements:
Stream port number should be even number.
If you are using multicast stream, ensure that you
have set valid multicast IP address.
Make sure that windows firewall is turned off.
MAIN PAGE
The MAIN PAGE is opened after the WebUI session has been established to the MPH100/400 series video encoder.
MPH100/400 encoder contains maximum six (6) encoding profiles,
which can be individually configured. On this page you can see each
profile’s current status and start/stop their video streaming.
Type:
Serial Number:
HW Version:
SW Version:
Uptime:
Current time:
Self Test Result:
Current Temperature:
PROPERTIES
Device type (configuration map code)
Device serial number
Device hardware version
Device firmware version
Device uptime
Device current time
Device test result
Current ambient temperature
STATUS
Type:
Encoder:
Multicast /Unicast:
Target Address:
Target Port:
Camera Status:
Stream Status:
SDP:
Here you can see each profile’s current status.
Stream type (Video)
Encoding format (H.264/MJPEG/MPEG-4,MPEG-2)
Video transmission mode (multicast/unicast)
Multicast: Multicast IP address / multicast group
Unicast: IP address of receiving decoder
UDP port number
Camera status (Ok/No signal)
Video stream status (On/Off)
Link to SDP file (Session Description Protocol). The SDP file contains
stream parameters that are meant for 3rd party applications (e.g. SW
decoders) to open/view the stream.
Download short term logs: Debug log file
Download long term logs: Debug log file
11
MPH100/400 series video encoders WebUI user manual