Download User manual

ONVIF PTZ service
1. In order to activate the ONVIF PTZ
protocol, data port mode must be first
set to the ONVIF PTZ service usage
from the Terminal Server page.
ONVIF PTZ service lets you control the camera from ONVIF client
application. ONVIF PTZ service is available from data channel 1. It
means that MPH converts ONVIF PTZ commands to Pelco D
commands and transmits that to the camera via Data channel 1.
2. Next on the PTZ Nodes page you need to set a Bus address for the
camera, you can have two cameras using the same Data port with different
bus addresses.
3. Then on the PTZ configurations page you can set limitations for PTZ
operations. For each PTZ node you can limit speed, pan, tilt and zoom.
TERMINAL SERVICE
1
(enable ONVIF PTZ on DATA 1)
2
(set a bus address for camera)
3
(set limitations for PTZ operations)
4
(PTZ configurations assignment)
PTZ NODE
PTZ CONFIGURATIONS
MEDIA PROFILE
Step-by-step flowchart how to
configure ONVIF PTZ data 1 channel
in the MPH encoder.
28
4. Finally on the Media profiles page you need to assign the PTZ
configuration to the media profile where the camera is connected to.
MPH100/400 series video encoders WebUI user manual