Download Scheduling Plus Manual
Transcript
Chronological Scheduling 2. Preparing to Schedule 1) Use the first program, Customize SC, to customize your school's block schedule. (Customizing your school's block schedule simply means that you will enter into the computer the order in which your period “blocks" meet each day.) This only has to be done the first time that you use Scheduling Plus. See the chapter in this manual on the Customize SC program for information on how Scheduling Plus' time system works and how to set-up your school’s block schedule. The Customize SC program is also used to enter the meeting times for each period block, as well as the day-ofthe-week headings as they will appear on students’ block schedules. 2) Use the second program, Enter Courses, to either construct your course master list for the first time or to modify last year's course master list. A sample course master list is shown on page i of the Appendix of this manual. A course master list is a list of all of the courses taught in your school which will later be broken down into one or more sections. Complete instructions for constructing your course master list are contained in the chapter of this manual entitled, ENTER COURSES: Course Master List. However, here are some additional notes: a. If you are entering your course master list for the first time, you must estimate the Optimum Size that you will need for each section of the course. (Note that you may have up to 250 students in each section.) After later obtaining tallies of how many students have signed up for each master course, the optimum sizes may be adjusted. b. If you offer semester courses that meet both semesters and that must be taken in a certain order, you must create a different master course for each section. For example, assume that MUSIC I and MUSIC II are semester courses that are offered both first and second semesters. If some students are going to sign up for both MUSIC I and MUSIC II, it is important that they are scheduled into MUSIC I before MUSIC II. To do this you might create the following: 5