Download User`s Manual for elegant

∗ xnumber — Number of subdivisions of pinhole in X (max 500)
∗ ynumber — Number of subdivisions of pinhole in Y (max 500)
– nphi=number — Specifies number of steps in phi between 0 and π/2. Must be less than
100. used in (calculation mode=1,2,3,4,5 calculation method=1,2).
– alpha=steps=integer,delta=value — Specifies the number of steps in angle alpha
(gamma*theta) (¡100). Delta specifies range of angles in alpha2 to be used, in units of
the angular equivalent to 1/N. Used in (mode=1, method=1) and method=3.
– omegasteps=integer,delta=value — Specifies the number of steps in photon energy
for the natural lineshape (¡5000). delta specifies range of photon energies to be included
in the natural lineshape in units (energy of fundamental/N). The default value covers
the range ±2/N of the natural lineshape. Used in mode=2,3,4,5 method=1.
– photonEnergy=maximum=eV,minimum=eV,points=number — Specifies the maximum and
minimum photon energy in eV, and the number of energy points to be computed.
• authors: H. Shang, R. Dejus, M. Borland, X. Jiao (ANL).
129