Download Operation Manual

FY operation manual
Chapter 3
EQUIPMENT ASSEMBLY AND ADJUSTMENT
3.1 Assemble Digital Printer
Screw
detachment
Screw
detachment
Figure 3-1 Packing screw’s detachment
Print head fixation
screw detachment
Screw
installation
Screw
installation
Ink tank
Figure 3-2 Screw installation and print head fixation screw detachment
1. According to the Pattern above, please assemble kickstand by following step: feet with truckle,
kickstand, and ink supply box.
2. Please tighten all Screws on the Feet; prepare to assemble the Core Part.
3. Please confirm carrying on assemble project with sufficient workmates, and then tighten all screws
with core part. Confirm no shaking occurs.
4. Install ink supply system on right side.
5. Please connect all data wire and power wire correctly.
3.2 Adjust Digital Printer
1. Make sure all data wire and power wire connected correct, and then Turn on your Printer.
2. Put media on the roll behind the Printer or insert single sheet paper on the printing table. Clamp the
pole on the right of Printer. The Printer detects the media width automatically.
-7-