Download ESPLXD-ET Controller

Water Windows
You can specify certain times of the day/night when irrigation is
allowed.
Otherwise watering is not allowed outside these “Water Windows”. This
is helpful to comply with local regulations which may prohibit irrigation
during certain hours.
AThe Delay Watering screen appears. Press the Down Arrow button
to select Water Window; then press Next.
BThe Water Window screen appears. Press the + and – buttons to
set the time when the Watering Window opens; then press Next.
llPress and HOLD buttons to accelerate settings for hours and
minutes.
CAUTION: Be sure a Water Window is sufficient to allow irrigation
dd
programs to run completely. Irrigation scheduled outside the
Water Window will not run but will resume when the Water
Window opens again. This can cause irrigation programs to “stack”
and eventually create an alarm condition if the controller stacks 8
or more programs.
1
2
NOTE: Water windows can be scheduled to cross midnight. For
bb
example, a Water Window can start at 10:00 PM and continue until
4:00 AM the next morning. Be sure your Watering Start Times are
set to occur within the Water Window. See Section A, Watering
Start Times for more details.
Set Up Water Window
Turn the controller dial to Delay Watering.
gg
CPress the + and – buttons to set the time when the Watering
Window closes. As you adjust the close time, the duration of your
Water Window calculates automatically.
NOTE: To clear a previously set Water Window, press the + and
bb
– buttons to set both the Open and Close times to OFF (between
11:59 and 12:00 AM).
DTo set another program, change the Program Select switch to the
desired program; a confirmation appears.
3
4
Repeat this process to set or clear Water Windows for other
programs as desired.
72
ESPLXD-ET Controller
ESPLXD-ET user-manual (670504-01) artwork_120716.indb 72
7/16/2012 3:48:24 PM