Download ESPLXD-ET Controller

BRoute the Rain Gauge wires through the knock-out on the bottom
Rain Gauge Installation
of the controller.
Install the Local Rain Gauge
Follow the Local Rain Gauge (ETM-RG) Installation Guide for proper
mounting of an optional Rain Gauge.
CUse
LOCAL RAIN
GAUGE
(with
tipping cup)
DPlug the blue 2-wire terminal with wires connected back into the
WIRE
NOTCH
the flat-head screwdriver (included) to connect the Rain
Gauge wires to the blue 2-wire terminal (included as a separate
piece with the ET Manager Cartridge – not included with the ETMRG). Give the wires a gentle tug to make sure they are securely
connected.
ET Manager Cartridge.
BRACKET
STRAIN
RELIEF
SLOT
RAIN
DRAINAGE
HOLES
RIVETS (2X)
RAIN
GAUGE
WIRE
CABLE
TIE
Connect the Local Rain Gauge
After the Rain Gauge is mounted properly, follow the steps below to
connect the gauge to the cartridge.
NOTE: When using the Local Rain Gauge (ETM-RG), the ET
bb
Manager Cartridge must be programmed with the Rain Source
set to “ETM-RG”. See the Rain Source section for programming
instructions.
AUnlatch the ET Manager Cartridge by pressing down on the latch
and pulling forward.
196
4
EInsert the ET Manager Cartridge into the cartridge bay bottom
edge first. Swing the top of the cartridge toward the front panel
and push into place, ensuring that the thumb latch snaps securely
into place.
FPress the Rain Gauge wire firmly into the cable routing channel
with the green/yellow ground wire, and the ET Manager Receiver/
Antenna Cable.
NOTE: If the ribbon cable becomes detached, re-attach with the
bb
RED edge of the ribbon cable toward the LEFT side of the opening.
ESPLXD-ET Controller
ESPLXD-ET user-manual (670504-01) artwork_120716.indb 196
7/16/2012 3:49:04 PM