Download Ness Macroscop VMS System

69
If the selected channel uses two streams, the Stream selection for analysis option is
available — you can choose either main or alternate channel (Alternate is selected by
default.)
Recommendations for selecting a stream for analysis; if the main one has
higher resolution than the alternate one (e.g., main — 1920x1080, alternate —
640x480):
- Alternate — if no intelligence analysis modules except for Macroscop software
detector are used.
- Main — if at least one additional intelligence analysis modules, including external
modules, is used with Macroscop software detector.
To configure a Macroscop software motion detector, select the required setting: simple or
expert.
Simple mode allows setting the minimum size of an object to be detected for the entire
frame. Analysis in this mode is carried out with the optimal frequency (see below.)
The minimum object size can be set in two ways:
 Interactively:
1.
Click Set in interactive mode — a minimum object size window will open.
2.
Hold down the left mouse button to select an area, which size corresponds to the
minimum object size.
3.
Click OK.
 Use the sliders to specify the minimum width and height as a percentage of the frame size.