Download TSU IQ User Manual

Chapter 11. Testing
Start Ping
Results are shown once you start the ping. The START PING
command causes the TSU IQ to send ten ping requests to the target
station. At the end of the ten-ping test, the following results are
shown:
Pings Transmitted (PINGS TX)
This field shows the number of pings sent (always 10).
Ping Responses (PINGS RX)
This field shows the number of responses received from the pinged
device.
Min Response Time (MIN RESP TIME)
This field shows the shortest round-trip delay (in ms) of the
received responses. Round-trip delay is counted from the time the
ping is sent until the response is received.
Max Response Time (MAX RESP TIME)
This field shows the longest round-trip delay (in ms) of the
received responses. If a response is not received before the unit
times out, the delay is not calculated in.
Avg Response Time (AVG RESP TIME)
This field shows the average response time (in ms) based on all
received responses.
61200215L1-1
TSU IQ User Manual
11-3