Download installation manual

INTRODUCTION
1
INTRODUCTION
This manual contains all the information required to install and calibrate the Planmeca
ProMax 3D Mid X-ray unit. Please read this manual carefully before installing the unit.
NOTE
You will also need the ProMax 3D Mid X-ray unit’s technical manual during installation.
The adjustment instructions are given in technical manual.
NOTE
The Planmeca Romexis software has a separate installation manual. You will also need
the Planmeca Romexis software user’s manual.
NOTE
The X-ray unit’s software revision is shown briefly on the control panel when the unit is
switched on. This manual is valid for software revision 1.0.0.0.r or later. This software
revision is compatible with Romexis software revision 2.4.0.r or later. Note, however,
that Didapi software revision 4.7.0.R or later is required for 2D imaging and SmartPan.
Installation manual
Planmeca ProMax 3D Mid 1