1
Download man pages section 7: Device and Network Interfaces
Transcript
idn(7d) these primitives enable or disable, respectively, the reception of all SAP (Ethernet type) values. When used with the DL_PROMISC_MULTI flag set in the dl_level field, these primitives enable or disable, respectively, the reception of all multicast group addresses. The effect of each is always on a per-stream basis and independent of the other SAP and physical level configurations on this stream or other streams. The DL_PHYS_ADDR_REQ primitive which returns the 6-octet, Ethernet address associated with (or attached to) the stream in the DL_PHYS_ADDR_ACK primitive. This primitive is valid only in states following a successful DL_ATTACH_REQ request. Because the driver maintains domain address information in the address to direct packets to the correct destination, the DL_SET_PHYS_ADDR_REQ primitive is not allowed. FILES The following files are supported: /dev/idn IDN special character device /platform/SUNW,Ultra-Enterprise-10000/kernel/drv/idn.conf System-wide and per-interface default device driver properties SEE ALSO netstat(1M), ndd(1M), dlpi(7P) domain_link(1M) in the Sun Enterprise 10000 SSP 3.2 Reference Manual. Sun Enterprise 10000 InterDomain Networks User Guide NOTES The idn driver supports a set of properties that can be set by using the driver.conf file for the IDN. See the Sun Enterprise 10000 InterDomain Networks User Guide for more information about the properties in the driver.conf(4), (idn.conf, for IDNs). Device and Network Interfaces 261
