Download Installation Manual ACURAS System

Transcript
Software/Hardware Control Verification
Verifying xRACU Communication
The xRACU tab can be used to verify and test control of the projectors through the xRACU software.
To verify xRACU communication:
1
Press the Initialize button to attempt to initialize xRACU communication.
Figure 8 shows the xRACU tab. The xRACU communications link has not been properly initialized.
Figure 8. xRACU Tab – Not Initialized
If the initialization is not successful, an error message appears that provides information for correcting
the situation.
One common reason for the xRACU connection initialization failure is that the xRACU software is not
in External Mode, a.k.a. IG Control mode. See the xRACU User Manual for information on how to
place the xRACU in External Mode.
13
PROPRIETARY NOTICE: The information contained herein is proprietary to Barco Simulation, LLC, and shall not be reproduced or disclosed in whole or in part, or used for any
design or manufacture except when the user possesses direct written authorization from Barco Simulation.