Download Installation Manual ACURAS System
Transcript
Software/Hardware Control Verification Verifying xRACU Communication The xRACU tab can be used to verify and test control of the projectors through the xRACU software. To verify xRACU communication: 1 Press the Initialize button to attempt to initialize xRACU communication. Figure 8 shows the xRACU tab. The xRACU communications link has not been properly initialized. Figure 8. xRACU Tab – Not Initialized If the initialization is not successful, an error message appears that provides information for correcting the situation. One common reason for the xRACU connection initialization failure is that the xRACU software is not in External Mode, a.k.a. IG Control mode. See the xRACU User Manual for information on how to place the xRACU in External Mode. 13 PROPRIETARY NOTICE: The information contained herein is proprietary to Barco Simulation, LLC, and shall not be reproduced or disclosed in whole or in part, or used for any design or manufacture except when the user possesses direct written authorization from Barco Simulation.