Download Installation Manual ACURAS System

Transcript
Software/Hardware Control Verification
Verifying IG Communication
The IG tab can be used to verify and test control of the IG image through the Polaris software.
To verify IG communication:
1
Press the Initialize button to initialize IG communication.
Figure 10 shows the IG tab. The IG communication link has not been properly initialized.
Figure 10. IG Tab – Uninitialized
If the initialization is not successful, an error message appears that provides information for correcting
the situation. One possible reason for the IG communication failing to initialize is that the IP Address
settings are incorrect.
2
To change the IP Address setting, press the Update IP Address button.
A dialog box appears allowing you to select a different IP Address. See Figure 11.
15
PROPRIETARY NOTICE: The information contained herein is proprietary to Barco Simulation, LLC, and shall not be reproduced or disclosed in whole or in part, or used for any
design or manufacture except when the user possesses direct written authorization from Barco Simulation.