Download INtime 6 Quick Start Guide

Prompt
Description
Network
configuration
Interfaces detected by the installer appear. Choose
the default system interface, used to connect to your
development system.

DHCP. Enter ‘y’ if you wish your network address to
be assigned by your local DHCP server

IP Address (if DHCP not selected). Enter an IPv4
address appropriate for your local network.

Netmask. Enter an appropriate netmask for your
local network.

Gateway. May be left blank, otherwise the address
of the forwarding gateway for your local subnet.

Type hostname.Should be a unique name
recognizable among the devices on your network.
Host name may contain only the ASCII letters 'a'
through 'z' (in a case-insensitive manner), the digits
'0' through '9', and the characters ('-',’_’).

Type Domainname. May be left blank, or choose
your local internet domain name. For
example,mydomain.com. Domain name has the
same character restrictions as hostname. Use '.' to
separate subdomain names.
SDK
Configuration
Enter the IP address or domain name for your
development system. This is used to connect your target
to the development system during development to grant
a license to the target. This connection is called
"tethering" and is described in the licensing section of
the User Manual.
Set
Administrator
password
This password is used to gain access to the web-based
configuration utility on the target. You can enter a blank
password if desired. If you enter a non-blank password
you are prompted to re-enter it for confirmation
purposes.
Reboot the
system
Remove the installation media and allow the system to
reboot
After rebooting, the INtime RTOS load process appears, as shown
below.
Copyright © 2005–2014, TenAsys Corporation
page 13 of 64