Download Roofing and walling

Transcript
Contents
Introduction
1
PART A: DESIGN
2
PART B: INSTALLATION
27
Design preliminaries
2.1 Product selection
2.2 Materials and finishes
2.3 Support spacings
2.4 Maximum lengths of roofing 2.5 Low roof pitches
2.6 Wind forces on roofs
2.8 Codes and performance tests
2.9 Environmental conditions
2.10 Metal and timber compatibility
2.11 Transportation
2
2
2
3
3
3
3
3
4
4
4
General care, safety and handling
7.1 Safety
7.2 Care and storage before installation
7.3 Handling cladding on site
7.4 Walking on roofs
7.5 Marking out, cutting and drilling
7.6 Clean up
7.7 Warn other contractors
7.8 Strippable coatings
7.9 Sealants
7.10 Maintenance
27
27
27
27
27
27
28
28
28
28
29
Installing pierce-fixed cladding
8.1 General installation procedure
8.2 Side-lapping & positioning pierce-fixed sheets
8.3 Pierce-fixing on crests
8.4 Pierce-fixing on valleys (for walling only)
8.5 Pierce-fixing on side-laps
8.6 Installing mini orb
31
31
33
33
34
34
34
Installing concealed-fixed cladding
9.1 Installing KLIP-LOK roofs
9.2 Installing KLIP-LOK walls
9.3 Installing EASYCLAD HI-TEN
9.4 Installing LONGLINE 305 roofs
9.5 Installing LONGLINE 305 walls
35
35
39
40
42
43
Ends of sheets
10.1 Turn-ups
10.2 Turning-down
10.3 Blocking off rib cavities
10.4 End-lapping
10.5 Expansion
10.6 Roof overhang with edge stiffener
44
44
46
47
48
50
51
Flashings
11.1 Materials
11.2 Longitudinal flashings
11.3 Transverse flashings 11.4 Flashing at change of pitch
11.5 Flashing large roof penetrations
11.6 Flashing small roof penetrations
11.7 Flashing walls
11.8 Bushfire protection
52
52
52
53
55
56
58
59
61
References
62
Index
63
Fasteners
3.1 Materials for screws
3.3 Materials for blind rivets
3.4 Materials for sealing washers
3.5 Identification of screws
3.6 Setting of screws
3.7 Quantity of fasteners and clips
3.8 Recommended fasteners and locations
9
9
9
9
10
10
11
11
Curved, bent & tapered cladding
4.1 Spring-curved-ridge roof
4.2 Spring-arched roof
4.3 Spring-curved concave roofs
4.4 Pre-curved roofs
4.5 Capped bent ribbed roofs
4.6 Tapered roofing
16
16
17
18
18
19
19
Insulation & skylights
5.1 Heat control
5.2 Condensation
5.3 Noise reduction
5.4 Insulation materials
5.5 Insulation thickness
5.6 Skylighting
20
20
21
22
22
23
23
Roof drainage
6.1 Introduction
6.2 Design of drainage (eaves-gutter system)
6.3 Gutter fall
24
24
24
25
Using LYSAGHT Roofing and Walling
2008-9 Edition