Download Software Manual WinIQSIM

Transcript
WinIQSIM
8.3.4.7
3GPP W-CDMA
Effect of Symbol Rates and Channelization Code Numbers
The channelization code generation method has the effect that with certain symbol rate/channelization
code combinations the identical spreading sequences Si/Sq are generated. This is always the case with
channelization code number 0 (all bits 0), but also with the combination 960 ksps/channelization code 1
(0011) <-> 480 ksps/channelization code 2 (00110011).
As a rule, the spreading sequences are identical if the products of symbol rate and
channelization code are identical.
The despreader therefore can no longer differentiate between the two channels. Depending on the data
contents, the channel powers are either added up or cancel each other. Restoring of all source data is
not possible.
Note:
Identical or overlapping areas in the code domain are indicated by WinIQSIM with a red
LED
.
The following signal contains
• a DPCH with 960 ksps, channelization code number 1, 0 dB, data all 0
• a DPCH with 480 ksps, channelization code number 2, 0 dB, data all 1
An analysis at 960 ksps gives the following result:
Fig. 8-72
Cancellation possible in case of several channels with identical spreading sequences
Apart from this trivial case there are other cases in which problems may occur.
The above example is modified by changing the channelization code of the second DPCH from 2 to 3:
• a DPCH with 960 ksps, channelization code 1, 0 dB, data all 0
• a DPCH with 480 ksps, channelization code 3, 0 dB, data all 1
After despreading at symbol rate 480 ksps, the following power distribution is obtained:
Fig. 8-73
Incorrect detection at various symbol rates
1013.1642.02
8-59
E-5