Download Fragment Analysis

Transcript
Part one Basics
3.10 Creating a standards file
The Standards Setup inspector (figure 3-10) allows you to create, load, or
modify a standards file. The standards file provides the information the
software uses to compute the unknowns.
3.10.1 Creating a new standards file
To create a new standards file, first select the type of file you will be creating
by clicking one of the buttons in the Type area. Next, in the Unit box, type
the appropriate unit for the value, such as bp, kb, or ng. In the Order box,
select the order in which you want the values listed.
Finally, in the Value box, type the first value, and then click Add or press
ENTER. The system adds the value to the list, inserting it in an appropriately
sorted order. Repeat to add more values.
To remove a value from the list, click the value, and then click Delete. To
change a value, click the value, type a new value in the Value box, and click
Change. To insert a value, type a new value in the Value box, and then click
Add. The value is inserted in the appropriate ascending or descending order.
3.10.2 Saving the new standards file
To save the new file, click the Save As button. The Save Size/Amount Standard
window appears. In the File Name box, type a name for the file, and then
click OK.
3.10.3 Loading an existing standards file
To load an existing standards file, select the standards type, and then click
Open to display the Open Size/Amount File window. Double-click the desired
standards file (or click the file name, and then click OK). The band values
appear in the Editor area of the inspector. (If you selected the wrong file, you
can select a new one.)
If a single standard serves as both size and amount standards, first load one
standards file type, and then the other. (Remember to specify the type before
clicking Open.)
For more information about using the Standards Setup inspector, see
section 9.4.
p3-20
●
Fragment Analysis User’s Guide