Download Fragment Analysis
Transcript
Part one Basics 3.10 Creating a standards file The Standards Setup inspector (figure 3-10) allows you to create, load, or modify a standards file. The standards file provides the information the software uses to compute the unknowns. 3.10.1 Creating a new standards file To create a new standards file, first select the type of file you will be creating by clicking one of the buttons in the Type area. Next, in the Unit box, type the appropriate unit for the value, such as bp, kb, or ng. In the Order box, select the order in which you want the values listed. Finally, in the Value box, type the first value, and then click Add or press ENTER. The system adds the value to the list, inserting it in an appropriately sorted order. Repeat to add more values. To remove a value from the list, click the value, and then click Delete. To change a value, click the value, type a new value in the Value box, and click Change. To insert a value, type a new value in the Value box, and then click Add. The value is inserted in the appropriate ascending or descending order. 3.10.2 Saving the new standards file To save the new file, click the Save As button. The Save Size/Amount Standard window appears. In the File Name box, type a name for the file, and then click OK. 3.10.3 Loading an existing standards file To load an existing standards file, select the standards type, and then click Open to display the Open Size/Amount File window. Double-click the desired standards file (or click the file name, and then click OK). The band values appear in the Editor area of the inspector. (If you selected the wrong file, you can select a new one.) If a single standard serves as both size and amount standards, first load one standards file type, and then the other. (Remember to specify the type before clicking Open.) For more information about using the Standards Setup inspector, see section 9.4. p3-20 ● Fragment Analysis User’s Guide