Download BitStorm 2600 and GranDSLAM 4200 IP DSLAM Command Line

3. Commands
Configure IGMP Snooping Querier Auto Detect
configure igmp-snooping querier-auto-detect
{enabled | disabled}
Minimum Access Level: Administrator
The configure igmp snooping querier-auto-detect command enables the unit to automatically detect
the port on which the IGMP querier is located. When this feature is enabled, the querier-interface
configuration has no effect.
All IGMP leave and join messages are sent to the port that has the IGMP querier.
enabled – The unit will automatically detect the active IGMP querier.
disabled – The unit will not automatically detect the port of the IGMP querier. The port must be specified
manually.
Example:
PDYN# configure igmp-snooping querier-auto-detect enabled
Configure IGMP Snooping Querier Interface
configure igmp-snooping querier-interface
{port_id}
Minimum Access Level: Administrator
The configure igmp snooping querier-interface command assigns an interface to be the IGMP
querier. All IGMP leave and join messages will be forwarded to this port. This feature has no effect when
the IGMP querier auto detect feature is enabled.
port_id – Any valid port ID. 1 through 48 for DSL ports, ppp1 through ppp8, mlppp1 though mlppp8,
eth1, eth2 or eth3.
Example:
PDYN# configure igmp-snooping querier-interface eth2
3-14
May 2006
2600-A2-GB21-50