Download PMC-5151 User Manual

ICP DAS PMC-5151 User Manual
 If the user wants to assign a Nickname for the address blocks,
the user can click on the “Nickname Setting” tab, and then input
the Nickname for each address block. The Nickname will be
shown in the “I/O Information” and “Rule Setting” pages.
 After all Input Register settings of the Modbus RTU module are
completed, click “OK” button to save the changes.
 The Holding Register Setting of Modbus RTU Module
The Modbus RTU Slave module Holding Register Setting page is
shown as follow:
Figure7-49 :
Holding Register Setting Page
The settings are as below:
 Data Model: WISE-580x offers 4 Data Model selections to
match the Modbus RTU Slave module configuration. Please
refer to the section “The Coil Output Setting of Modbus RTU
Module” for detailed information. In this case please select ”
Holding Register (4x)”.
 Start Address: Allows to set up the starting address of Holding
105