Download OneFS 6.5.4 User Guide

Transcript
The Isilon SyncIQ module
•
•
•
the fully qualified domain name of any node in the target cluster
the name of a SmartConnect zone in the target cluster
the IPv4 or IPv6 address of any node in the target cluster
Type the Name or address value carefully; the system does not validate the data that you enter.
Note: SyncIQ does not support dynamic pools.
Note: Depending on whether you are creating a new SyncIQ policy or modifying an existing policy, the
name of this page is either SyncIQ Add Policy or SyncIQ Edit Policy.
2. Click one of the following options to specify which nodes on the target cluster to connect to when the SyncIQ job
runs:
These settings are applicable only if you specified a host name, domain name, or SmartConnect zone name in the
target cluster Name or address box. They are not applicable if you specified an IP address.
•
•
Connect to any nodes in the cluster: Connect to any available nodes on the target cluster.
Connect to only the nodes in the subnet and pool if the target cluster name specifies a SmartConnect zone:
Connect to only the target-cluster nodes that are contained in the subnet and pool that you specified in the target
cluster Name or address box, if you specified a SmartConnect zone.
3. In the Target directory box, type the absolute path (beginning with /ifs) for the target-cluster directory to which
files will be replicated.
! Caution: Do not specify a target directory that is already specified as the target directory of a different SyncIQ
policy.
Note: In most cases, you should not specify /ifs as the target directory; doing so would prevent you from
using the target cluster for any purposes other than as a SyncIQ target because the entire cluster would be put
into a read-only state and all of the data contained in /ifs would be overwritten each time the job runs.
If the specified target directory does not already exist on the target cluster, the directory will be created the first time
the job runs. For synchronization jobs, if the directory already exists on the target cluster, all files in that directory
will be deleted. For copy jobs, target files may be overwritten with source files.
To save the policy, you must complete each of the remaining steps in the SyncIQ policy-configuration process. The next
step in the process is configuring target-cluster snapshot settings. For more information, see Configure SyncIQ policy
target-cluster snapshot settings on page 143.
Configure SyncIQ policy target-cluster snapshot settings
For each SyncIQ policy, you can optionally configure SyncIQ to save a snapshot of the data set on the target cluster
after each job is complete.
Prerequisite: This is the fifth of seven steps required to configure a SyncIQ policy. Before you configure target-cluster
snapshot settings, you must configure general target-cluster settings. For more information, see Configure SyncIQ policy
basic target-cluster settings on page 142. To use the target-cluster snapshot feature, the Isilon SnapshotIQ module must
be licensed and enabled on the target cluster. To obtain a SnapshotIQ license for your target cluster, contact your Isilon
sales representative.
1. On the SyncIQ Add Policy page, in the Target Cluster Snapshot area, configure target-cluster snapshot settings
as necessary.
Note: Depending on whether you are creating a new SyncIQ policy or modifying an existing policy, the
name of this page is either SyncIQ Add Policy or SyncIQ Edit Policy.
2. If you want to automatically create a snapshot on the target cluster after each job completes, in the Snapshots section,
click Create a snapshot on the target cluster.
©
2011 Isilon Systems, LLC.
143