Download Manual - ETS

INITIATE MOVEMENT
From the EMControl screen use the
Down button or Up button for a linear device like
an antenna mast; use the CCW button or
CW button for a rotational device like a
turntable. Depending on the mode, these
buttons will cause a different reaction. The
mode can be set to Jog, Step, or Run.
 Jog mode—Movement continues as long as the
button remains pressed. Releasing the button will
stop the movement.
 Step mode—Each button push will result in motion
defined by the step size. Step size is configured in
StepSize on the Configuration screen; see
Change Other Settings on page 27.
 Run mode—A button push initiates movement.
Movement stops only when the Stop button is
pressed.
24
Operation
ets-lindgren.com