Download Manual - ETS

CP
Description:
Changes the current position of the device. Value must be
between –999.9 and 999.9.
Devices:
Towers, turntables
Syntax:
CP [+/-] XXX[.X]
 + : Optional for positive values
 – : Necessary for negative values
 XXX[.X] : Decimal value for the current position to be set in
centimeters for towers and degrees for turntables.
.X is optional. Leading zeroes are optional.
Response:
OK, or an error (error number)
Example:
Write sdCP 100.7\n : Change tower current position to 100.7 cm
See Also:
CP?
40
EMControl Command Set
ets-lindgren.com