Download Manual - ETS

Transcript
SKN
Description:
Instructs the device to begin seeking the specified target value in
the negative (down/counterclockwise) direction only.
If the target is up/clockwise from the current position, no motion
occurs. The target must be located between the current
upper/clockwise and lower/counterclockwise limits.
This command is provided primarily to support continuous
rotation turntables and reverberation paddles. It allows forcing the
seek of a position from a particular direction. Thus, a SKN from
180.0 to 181.0 will rotate counterclockwise to reach the target
value.
Devices:
Turntables, towers
Syntax:
SKN [+/–] XXX[.X]
 + : Optional for positive values
 – : Necessary for negative values
 XXX[.X] : Decimal value for the seek target in centimeters for
towers and degrees for turntables. Leading zeroes are
optional.
Response:
OK, or an error (error number)
Example:
Write sdSKN 100.0/n : Instruct tower boom to seek 100.0 cm if
CP > 100.0 or turntable to seek 100.0 degrees if CP > 100.0 in
continuous rotation mode
See Also:
SK, SKP, SKR
62
EMControl Command Set
ets-lindgren.com